Tianjin Bobei cold storage refrigeration unit equi

Time：2016-12-04  Author：  Hit：1104

Cold storage in the compressor from the evaporator closer to the more good, so not only easy to repair, but also good heat dissipation. The installation should pay attention to early outdoor rain, the host four angle need to be placed shockproof pad, Caution! Level installation is firm, not easy to be touched.
    1, copper emissions: all are wearing brass pipe insulation wire with the same direction together with the air conditioning tie together up, try to walk straight and sectional fixing pipe insulation and thermal insulation pipe joint with electrical tape sealing.
     2, installation: radiator radiator installation position closer to host the better, the best in the host partial host, who have the best heat radiator installation environment, not to the other equipment inlet outlet, especially oily gas outlet can not be short circuited or elsewhere at window (especially residential window) and equipment from the ground should be 2M high level of strong earthquake installation.

3, electrical wiring performance configuration: wire diameter to meet the requirements, the joint is strong, the need to protect the tube can not be saved, then the correct power. Wire into the evaporator junction box, the need for silicone seal, the lamp, such as 36V or above is required to be grounded, the main power cabinet into the three-phase five wire system, to have a reliable grounding Connect .

4, refrigeration system: because the main condenser and evaporator in the factory after the pressure seal, thus opening, should have pressure, check whether there is leakage, the factory should have two copper dust measures, the construction should also pay attention to at any time to seal waterproof dust into the tube,